1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II Ecu Flashing/Coding
  4. CAS-ELV a11a CAS: ELV fault / stays active after CAS update and ELV reset counter
asim
  •  asim
  • 69.6% (Friendly)
  • Member Topic Starter
2019-03-14T22:45:33Z
Hi,
Working on E81 with "a11a CAS: ELV fault". Performed CAS-ELV reset counter, fault a11a changed from active to history, could erase fault. After ignition cycle still no joy and fault "a11a" comes back.
Updated CAS to latest version. Performed CAS-ELV reset counter, again, fault a11a changed from active to history, could erase fault. After ignition cycle still no joy and fault "a11a" comes back.
Any suggestions to fix this with Autohex by software instead of replacing the steering column?
Best regards,

Added on 15 March 2019 08:50 (GMT+1):
I also did try to "reset CAS". This results in "not OK"
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

bratick
2019-03-15T08:22:55Z
Have similar issue with 6 series once, in my case help steering alignment calibration in service option
AUTOHEX_BMW
2019-04-04T07:26:53Z
I have put here on forum cas3+ flash without elv. Write flash, pull out elv then start car
Similar Topics
Users browsing this topic
  1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II Ecu Flashing/Coding
  4. CAS-ELV a11a CAS: ELV fault / stays active after CAS update and ELV reset counter