1. Microtronik Autohex II and Hexprog forum
  2. HexProg Programming Tool
  3. HexProg Intro
  4. MED9.5.10 hexprog factory mode error
applerallph
2021-08-10T15:54:12Z
Factory mode not working on MED9.5.10 (2.0 FSI) . Tried both connections in hexprog wiring diagram still no ecu read in factory mode its only reading in boot mode.
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Autohex_II_BMW
2021-08-11T05:52:37Z
Originally Posted by: applerallph 

Factory mode not working on MED9.5.10 (2.0 FSI) . Tried both connections in hexprog wiring diagram still no ecu read in factory mode its only reading in boot mode.



what error you were getting on software.
applerallph
2021-08-11T07:36:10Z
Mode -Ref: 160- Cannot communicate with ECU Using factory mode
Autohex_II_BMW
2021-08-11T08:26:28Z
Originally Posted by: applerallph 

Mode -Ref: 160- Cannot communicate with ECU Using factory mode



this error means no communication please contact support on live chat.
applerallph
2021-10-09T09:23:20Z
..would be great to read and write this ECU in factory mode it just cuts out in the middle of reading . ECU is water proof would be much great to just read it nicely in factory mode wish this error could be fixed !! Software pops out Ref:161
Autohex_II_BMW
2021-10-09T14:04:26Z
Originally Posted by: applerallph 

..would be great to read and write this ECU in factory mode it just cuts out in the middle of reading . ECU is water proof would be much great to just read it nicely in factory mode wish this error could be fixed !! Software pops out Ref:161



its supported in factory mode if you are getting error 160/161 can be of multiple reasons . Please contact support.
Similar Topics
Users browsing this topic
    1. Microtronik Autohex II and Hexprog forum
    2. HexProg Programming Tool
    3. HexProg Intro
    4. MED9.5.10 hexprog factory mode error