1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II DME/DDE and CAS ISN
  4. CAS and used DDE ISN - old DDE damaged
BMWZG
  •  BMWZG
  • 100% (Exalted)
  • Advanced Member Topic Starter
2016-10-04T14:46:41Z
Hello ,
Is there any possilbility with AutohexII to sync ISN between CAS4 and EDC17CP45 in F11 525D ? The problem is that I have car with damaged original DDE so I can't recover ISN from it. Is there any possilbility to read them from CAS 4 with AutohexII or I must use CAS BDM programmer ?
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Autohex_II_BMW
2016-10-04T15:54:47Z
Check your CAS4 if EWS5 is active or not.
if CAS4 EWS5 is active, no solution for this case.
If CAS4 EWS5 not active, you can modify ISN by DUMP.
BMWZG
  •  BMWZG
  • 100% (Exalted)
  • Advanced Member Topic Starter
2016-10-05T07:21:45Z
Unfortunatelly EWS5 is active but I have dump from CAS d-flash.
 CAS4.jpg You have insufficient rights to see the content.
Autohex_II_BMW
2016-10-05T13:12:23Z
We are working on finding a solution for cases like your case.
But it will not be ready very soon!
Similar Topics
Users browsing this topic
  1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II DME/DDE and CAS ISN
  4. CAS and used DDE ISN - old DDE damaged