CLONE ME17.9.71 · Microtronik Autohex II and Hexprog forum

Welcome Guest! To enable all features please Login or Register.

meysen
52% (Neutral)
Newbie Topic Starter

2021-01-05T17:33:02Z

HI
lastweek i write above ecu with other flash dump(same model) and all was ok -engine worked no problem.
but today i could not read or write it and fail unlock ecu.
so try many time but same error.
i think it changed the pass and in this case what i do?
thanks.

Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Wanna join the discussion?! Login to your Microtronik Autohex II and Hexprog forum forum account or Register a new forum account

Autohex_II_BMW
100% (Exalted)
Advanced Member

2021-01-06T06:03:22Z

Originally Posted by: meysen

HI
lastweek i write above ecu with other flash dump(same model) and all was ok -engine worked no problem.
but today i could not read or write it and fail unlock ecu.
so try many time but same error.
i think it changed the pass and in this case what i do?
thanks.

can you please attach photo for the error you are getting. we recommend you to contact via skype or WhatsApp on below details for more convenience.
Skype: microtronik@outlook.com
WhatsApp: +971555827622

meysen
52% (Neutral)
Newbie Topic Starter

2021-01-24T17:22:16Z

HI
I tested several times.
I found the problem that when the flash file changes, it can no longer read the original password and unlocks it, while some devices prevent the original password from being changed, and you can program the ECU many times.

Autohex_II_BMW
100% (Exalted)
Advanced Member

2021-01-25T05:54:57Z

hi,
this ecu password look like is in otp portion so even if you write another file or dump password wont change as like siemens and continental ecu, it must communicate. if you have original backup of ecu please restore that back to ecu in boot mode and check if ecu back to normal.