MD1 and MG1 (MDG1) ISN Reading of following DME/DDE (writing is possible for some DMEs):
MD1 and MG1 (MDG1) ISN Reading of following DME/DDE:
Autohex II reads and writes all ISN of DME/DDE in F series:
Autohex II reads all ISN of DME/DDE in E series:
Autohex II reads the ISN of DME/DDE in E series:
Autohex II is the most advanced tool for BMW Ecu programming, it supports E series, F Series and G Series
With Autohex II you can read and write ISN from all CAS versions in E and F series
This function is important when the DME/DDE is not responding, and you need the ISN for replacement
You can reset EWS security from all BMW E series EGS by OBD
You can reset EWS in EGS 6HP (On Bench) and 8HP by OBD or On Bench
Autohex II calculates the required coding data automatically from the car vehicle order, then it applies these data to the target module
You can modify the Ecu coding to add and remove features in any Ecu in BMW cars
You can modify the Vehicle Order to do retrofit the configuration. You can also backup and restore the FA from the backup Ecu
CAS1, CAS2, CAS3, CAS3+, CAS4 ,CAS4+, FEM and BDC are supported by Autohex II, this includes if all keys lost
You can unlock security of CAS4/4+, BDC and FEM to able to:
With Autohex II you can read ISN of MSD80, MSD81, MSD85, MSD85Y, MSD87, MSV90 in E/F series on Bench without opening the Ecu.
Hextag is a powerful tool for Ecu cloning, Chip tuning, All CAS versions read/write and Key/EEPROM Reset, with Hextag:
